C Specification

To dynamically enable or disable the stencil test, call:

// Provided by VK_EXT_extended_dynamic_state
void vkCmdSetStencilTestEnableEXT(
    VkCommandBuffer                             commandBuffer,
    VkBool32                                    stencilTestEnable);


  • commandBuffer is the command buffer into which the command will be recorded.

  • stencilTestEnable specifies if the stencil test is enabled.


This command sets the stencil test enable for subsequent drawing commands when the graphics pipeline is created with VK_DYNAMIC_STATE_STENCIL_TEST_ENABLE set in VkPipelineDynamicStateCreateInfo::pDynamicStates. Otherwise, this state is specified by the VkPipelineDepthStencilStateCreateInfo::stencilTestEnable value used to create the currently active pipeline.

Valid Usage
  • VUID-vkCmdSetStencilTestEnable-None-08971
    At least one of the following must be true:

Valid Usage (Implicit)
  • VUID-vkCmdSetStencilTestEnable-commandBuffer-parameter
    commandBuffer must be a valid VkCommandBuffer handle

  • VUID-vkCmdSetStencilTestEnable-commandBuffer-recording
    commandBuffer must be in the recording state

  • VUID-vkCmdSetStencilTestEnable-commandBuffer-cmdpool
    The VkCommandPool that commandBuffer was allocated from must support graphics operations

Host Synchronization
  • Host access to commandBuffer must be externally synchronized

  • Host access to the VkCommandPool that commandBuffer was allocated from must be externally synchronized

Command Properties
Command Buffer Levels Render Pass Scope Supported Queue Types Command Type





See Also

Document Notes

For more information, see the Vulkan Specification

This page is extracted from the Vulkan Specification. Fixes and changes should be made to the Specification, not directly.

Copyright 2014-2023 The Khronos Group Inc.

SPDX-License-Identifier: CC-BY-4.0